Knowledge Base:  
Knowledge Base Category 16 does not exist.

Page of 1
DMX Wiring Cross Reference
HolidayCoro devices that use CAT5 wire for DMX signals (excluding E1.31 devices) are intended to be wired using pins 1 and 2 of CAT5 wiring (568B) for their RS485 DMX input signal. If you are usin
How much power do I need for LEDs/RGB Modules/Nodes/Strip/RGB Elements?
You can use any 12v power supply that will supply the correct amount of current with our RGB lights - you do not have to use our 12v waterproof power supply . For some of our RGB products ( Cor
How to terminate an RS-485 CAT5 DMX line
Programming your HolidayCoro DMX Controller using your HolidayCoro Programmer/Dongle (video)
The following video shows how to setup your USB programmer/dongle to program your HolidayCoro 3 channel DMX controller.    
Testing DMX output using your HolidayCoro DMX Programmer/Dongle (video)
The following video shows how you can use xLights (a free application) to test your HolidayCoro DMX controllers with the HolidayCoro Programmer/Dongle.  Using this test you will be able to deter
Wiring Up and Programming your HolidayCoro DMX Controller (flow chart and videos)
When setting the address via the DIP switches on the controller (accessible after removing the two screws and the cover of the controller), here is the chart for setting the address: http://www.holid