Knowledge Base:  
Knowledge Base > --> Knowledge Base >
Wiring Up and Programming your HolidayCoro DMX Controller (flow chart and videos)
Last Updated: 12/06/2015
When setting the address via the DIP switches on the controller (accessible after removing the two screws and the cover of the controller), here is the chart for setting the address:

http://www.holidaycoro.com/kb_results.asp?ID=88

Attaching RGB Modules to the HolidayCoro DMX Controller


Attaching Power Supply to the HolidayCoro DMX Controller


Attaching the Signal Cable to the HolidayCoro DMX Controller




How helpful was this article in answering your question?

Comments / Feedback / Corrections (please, no questions):
 

Related Articles
 > Can I download my sequences/software directly from your website?
 > How to use HolidayCoro RS485 Based DMX controllers with your favorite sequencing application
 > DMX Programmer/Dongle Instructions
 > DC Controllers - Basics (Presentation)
 > How much power do I need for LEDs/RGB Modules/Nodes/Strip/RGB Elements?
 > How big of a power supply will I need for RGB lights?
 > Testing DMX output using your HolidayCoro DMX Programmer/Dongle (video)
 > Programming your HolidayCoro DMX Controller using your HolidayCoro Programmer/Dongle (video)
 > DMX Wiring Cross Reference
 > Using a Screen Recorder to document a PC based problem.
 > What lighting controllers do your products work with?
 > How to terminate an RS-485 CAT5 DMX line
 > How to build a RGB Power Injector
 > DIP Switch Addressing Chart
 > Smart / Intelligent Pixel Controllers Compatible with HolidayCoro Pixel Lights
 > Running Legacy RS485 Light-o-Rama Controllers and RS485 Based DMX (E1.11) and Ethernet Based (E1.31) DMX Controllers Together
 > PixLite Technical Support Page
 > How to link multiple Ethernet based AlphaPix controllers together / Multiple IP Addresses
 > Do HolidayCoro Controllers Work With Light-o-Rama Software