Home > DIY Products > RGB Lights / Bulbs / Strip > Smart / Pixel RGB Lights - Strip / Tape / Ribbon / Rolls >

Smart / Pixel RGB LED Strip 30 LEDs/m 10 Pixels/m / Pre-Attached 10 Foot Waterproof Input Cable / Waterproof Tube (16ft-6in/5 meter Roll) - 12v / 2811 or 1903 / BRG Color Output Order



 
Our Price: $24.99

Availability/Ships: Usually Ships in 24 Hours
Product Code: 705-WP
Qty:

[Product Description Page] [FAQ & Documentation Page]
 
.
Hands on with the product
Product Features
  • Features
    • Please note that these require a smart pixel controller - these will not work with dumb controllers!
    • Design for pixel strip MegaTrees removing the need for extension cables
      • See our pixel MegaTree kits that include this type of pixel strip
    • Smart / Pixel Strip
    • Pixel protocol WS2811 and UCS1903 (supported by every major pixel controller)
    • Viewing angle of 120 degrees
    • Pre-Attached Waterproof connection
      • 3 Pin cable
      • Input side
        • Male pins
        • 10 Feet (304cm)
      • Output side
        • Sealed
      • Compatible with all HolidayCoro 5, 10 and 20 ft 3 core extension cables (see here for listing of cables)
    • White PCB circuit board background
  • Lights
    • Total LEDs per Strip: 150 of 5mm x 5mm (5050) RGB LED Lights
    • Total Individually Controllable Sections per Strip: 50 Sections (10 per meter) - each 4" in length, contain 3 RGB LED lights per section
    • Total DMX channels required: 150 DMX Channels (50 sections, each with three channels - Red, Green, Blue)
    • Color Output Order - BRG
  • Dimensions
    • Overall length is 5 meters or about 16 feet, 6 inches
    • Width of strip without protective boot: .393" / 10mm
    • Width of strip with protective boot: .492" / 12.5mm
    • Height of strip without protective boot: .125"/ 3.18mm
    • Height of strip with protective boot: .160" / 4mm
  • Weather
    • Silicone "boot" covers entire length of strip providing typical weather resistance
    • Ends are silicone glued to ensure weather tightness
    • Not intended for use underwater
  • RGB LED Chip (5050) Testing Specs:
    • 1,000 hours at 212f
    • 1,000 hours at 32f
    • -40f to 212f over 15 minutes, 40 times without failure
    • 50,000 hours (estimated) at 76f
  • Wiring colors:
    • Red = Power Input Anode/+/Positive
    • Black = Power Input Cathode/-/Negative
    • Yellow = Data Signal
    • See photos on this page for pin out map
  • Power
    • 12v DC Input
    • White (all three colors) Entire Roll: 3 amps / 36 Watts
    • 2.4 Watts per Foot / 7.2 Watts per Meter
  • Packaging
    • Each strip ships on a plastic reel, packed in a plastic, anti-static envelope.
    • Wiring instructions are provided on the outside of the envelope.
  • Lumens Output
    • The following table is listed PER 5050 LED:
      Minimum Maximum Unit
      Red400600 mcd
      Green 16002000 mcd
      Blue 300400 mcd
  • Color Output Wavelengths
      Minimum Typical Maximum Unit
      Red 620 623 626 nm
      Green 515 518 521 nm
      Blue 465 467 469 nm

Average Rating: 5 of 5 Total Reviews: 3 Write a review »

  0 of 0 people found the following review helpful:
 
Smart RBG LED strips November 16, 2017
Reviewer: Martin Chavis from Laurel Hill, NC United States  
Excellent product, and awesome support! Thanks David!

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Awesome Strips October 6, 2017
Reviewer: Aaron Fadler from Mount Vernon, IL United States  
Love these strips, color is consistent from one strand to the next. We also like that we could use these strips with 30ft of extension cable without any problems!

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
High Quality September 26, 2017
Reviewer: Roger Gallagher from Bethany, OK United States  
These pixel strips were the best price and the best quality.

Was this review helpful to you?