16 SPI Output Ready2Run SMART Long Range Receiver with Screen

Product Features

Fully wired and ready to run - just plug in your CAT5 data cable from your Flex Long Range Expansion board (DIY and Ready2Run)
One 16 Output Long Range SPI Board
Requires HinksPix PRO CPU with the Flex Long Range Expansion Board
- Does not work with AlphaPix Evolution CPU
- Does not work standalone (using Ethernet or "DMX")
- Third party Long Range controllers will not work with this receiver - it is designed for use with HolidayCoro Long Range boards
Includes build in OLED Screen that shows
- Address identification
- Test modes
- Data status
Pigtails are labeled with output number (1 through 16) and voltage for easy identification
- Fully clamped and strain relieved clamps for pigtails
Three waterproof bottom access CAT5 jacks (1 input, 2 output)
One or two 350w power supplies (120 or 240 volts input)
- 5 or 12 Volt output
- Dual power supplies can be different voltages in banks 1, outputs 1 to 8 and bank 2, 9 to 16
Power cord specific to your country
Mounted in waterproof HC-2500 outdoor rated enclosure

Button Interface Menu Path
PRESS AND HOLD ENTER/EXIT TEST MODE (Blue LED will turn on to indicate you are in configuration/test mode)
- Main menu
  - Screen
    - "V 4.1" or similar indicates the version of firmware installed on the receiver
    - "NO CONFIG" indicates xxx
    - "AFTER RESET" indicates xxx
    - "A YES" or "A NO" indicates that the bank of outputs (see below) are programmed by the controller (YES) or not programmed (NO). This will also be indicated by the green LEDs "ABCD ACTIVE".
      - A = OUTPUTS 1 to 4
      - B = OUTPUTS 5 to 8
      - C = OUTPUTS 9 to 12
      - D = OUTPUTS 13 to 16
- S Button
  - Using the + and - buttons, navigate to the options below and then press the S button to select the option
  - TEST PIXELS
    - Using the + and - buttons, navigate to the options below and then press the S button to select the option
    - MODIFY PORTS
      - CHANGE RCVR DATA (this is not an option, only a header to let you know you are in this mode)
      - CHANGE ID A (0)
        PRESS S
        RCV A WANT ID x
        Where x is the ID you wish to change
        Note that this is a chaining receiver, thus you only need to change the first A ID to change the remaining IDs
      - STARTING PIXELS
        Via this option you can change the starting location of the port in the data stream. We do not recommend changing this directly, use the controller design tool or xlights Visualizer
      - LOCK RCVR
    - PORTS A & B / PORTS C & D
      - Both above options are the same in operation but apply to each bank as marked on the board
      - Press S to enter sub-menu
        DISPLAY RED
        DISPLAY GREEN
        DISPLAY BLUE
        DISPLAY WHITE
        Use the + and - buttons to select the color of the output you wish to test, then select the S button to invoke the test. The pixels attached to the A & B OR C & D ports
    - FIRMWARE x.x
      - Not a changeable option, only shown to show version of installed firmware
  - CONFIG BOARDS
  - RIBBON PORT
  - FACTORY RESET