Ready To Run RGB Pixel Ribbon Strip Arch Kit

Product Features
This Pixel Package allows you to build four pixel arches using this kit and a few inexpensive items from the hardware store. This kit features:

A modern E1.31 Pixel controller, weather proof mounting enclosure, power supply and all necessary cabling
Fully wired and ready for installation into your display
Fully compatible with LOR S3, LightShow Pro, Vixen, Nutcracker, HLS, Madrix and many other E1.31 and ArtNet sequencing and control software.
Designed for two arches on each side of the controller with up to 7 feet between arches
Can be expanded in the future for up to 9 arches with the same power supply and controller
Includes black Velcro for attaching pixel strip / ribbon to the PVC mounting pipe

You will need the following items, in-addition to the items purchased in this kit to complete your arch kit:

Eight 2 Ft long sections of rebar (to mount the PVC pipe)
72 Feet of 3/4" PVC pipe (for mounting strip)
Misc Ethernet networking switch/wiring as required for E1.31/ArtNet

For customers that wish to add an additional strip for displays that require 360 degree viewing on both sides of the PVC mounting pipe, the following can be added to the kit without any changes in the controller or power requirements:

Shown below is the typical height and width of a "perfect" uncompressed arch. Arches can be lowered in height and made wider as needed.