Home >

5 Amp Fuse for Flex Expansion System 16 SPI / AlphaPix 16 Classic / EasyLights 16 / Flex Receivers
PRODUCT PHOTO: 5 Amp Fuse for Flex Expansion System 16 SPI / AlphaPix 16 Classic / EasyLights 16 / Flex Receivers


 
Our Price: $0.29

Availability / Ships: Usually Ships in 24 Hours
Product Code: 875
Qty:

[Product Description Page]
 
.
Change Fuse on Flex Stacked SPI Expansion Boards
Product Features
Process for replacement of fuses on different boards:
  • AlphaPix Classic 16 V1 - V3
    • Locate bad fuse by process of troubleshooting (see video below)
    • Pull fuse either with your fingers or needle nose pliers
  • Flex SPI Expansion Board
    • 1 SPI Board or 2 SPI Boards (top board)
      • Locate bad fuse by looking for location WITHOUT red LED lit, this indicates a bad fuse when the light is OFF
      • 30mm spacing: Use needle nose pliers to remove and replace fuse
      • 40mm spacing: Use your fingers or needle nose pliers to remove and replace fuse
    • 2 or 3 SPI Boards (bottom board)
      • Turn off power to unit
      • Unplug ribbon cables from top of CPU board
      • Unplug CAT5 network cables, fan wiring and/or audio jack cable from CPU board
      • Remove four 5.5mm or 7/32" nuts from top of CPU board
      • Remove CPU board
      • Unscrew four screws on right power input to allow SPI output board to be pulled away
      • Move SPI board out of the way to access the SPI board underneath top SPI board
        • Note: It is not necessary to disconnect pixel output cables
      • Replace fuse using your fingers or needle nose pliers
      • Reinstall board in reverse order

Share your knowledge of this product. Be the first to write a review »