 |
Product Features
- Features
- Reverse-able - one candy cane can be right or left depending side of the cane the nodes are installed
- Uses standard "12mm" bullet type pixel nodes or dumb nodes
- Not for use with square or flat nodes
- Made from Bubble-X material which is 4 times stronger than regular corrugated plastic material
- Includes slots for clamps or zip ties going up pole
- Sizes / Specifications:
- 36 Inch / 99 Pixels
- 14" at the widest point (hook)
- 35.5" Tall
- 3.8" Thick / Wide
- 3 rows of 33 pixels each
- Recommended pixels:
- Assembly time
- Typically 15 to 30 minutes
- Fully assembled, no splices
- 89 Inches / 200 Pixels
- 33" at the widest point (hook)
- 89" or 7 Feet 5 Inches Tall
- 8.9" Thick / Wide
- 4 rows of 50 pixels each
- Install pixels starting at bottom, go to top, loop around and end at bottom, repeat again
- Recommended pixels:
- Assembly time
- Ships un-assembled, requires zip ties for final assembly
- Includes two splice plates
- Notes
- Highly recommend using steel band clamps and 3/4" EMT or simular piping to support
- Mounting
- Mount using standard 1/2" EMT Conduit or "T-Stakes" using one of two methods:
- Zip Tie Holes
- 12 Velcro or steel band clamp slots
- Additional features
- Two sets of cord strain relief's at base to relieve strain on cables (.25" diameter)
- 2" Base gap to allow for nodes to completely show when obstructed by snow, grass or leaves
- Product origin
- Material: USA (Texas)
- Design: USA (Texas)
- Manufacturing: USA (Texas)
- Additional items required to complete
|
|
|
Great Product 
Good!