Knowledge Base:  

Page of 1
DIP Switch Addressing Chart
Below is the link to our DMX Address DIP Switch Setting Chart: Download PDF Switch Chart NOTE: On HolidayCoro dumb DMX controllers, DIP switch 10 turns on test mode. It may be necessary to tu
Running E1.11 / DMX 1990 Controllers (EasyPix, Dumb Controllers) from AlphaPix RS485 Interface
The AlphaPix pixel controller has the ability to output legacy, DMX 1990 / E1.11 data using RS485 to legacy controllers such as the EasyPix , common dumb RGB and non-RGB controllers and devices such a
EU Member Country Shipments
As of 30-Jun-2021 we no longer ship directly to EU countries We are sorry but due to changes by EU governments to place additional tax collection requirements on shippers outside these countries, we
SD Card Not Reading or Working with HinksPix PRO CPU
PROBLEM: When attempting to save your configuration information when using the design tool or when attempting to play a sequence created with the HSA application, your SD cannot be read or written to.
DMX Wiring Cross Reference
HolidayCoro devices that use CAT5 wire for DMX signals (excluding E1.31 devices) are intended to be wired using pins 1 and 2 of CAT5 wiring (568B) for their RS485 DMX input signal. If you are usin
Wiring Up and Programming your HolidayCoro DMX Controller (flow chart and videos)
When setting the address via the DIP switches on the controller (accessible after removing the two screws and the cover of the controller), here is the chart for setting the address: http://www.holid
Troubleshooting: xLights Confirmation Capture
You have been directed to this page due to a reported configuration issue with xLights software. This page provides information on how to properly capture the information that our HolidayCoro technica