|
|
|
|
|
|
|
Product Features
This cable and coupler allow you to convert the output of a standards based (E1.11 / DMX 1990) DMX output (Actidongle, PixLite Controllers) on CAT5 cable to drive an LOR controller in DMX mode. This cable switches the 1/2 pair to the 4/5 pair. The wiring for this cable can be found in our knowledge base article on DMX wiring standards.
Please note that if you have existing sequences setup for use with LOR controllers, you will need to adjust those sequences to output on the correct DMX output/Universe and channel for each LOR controller. For more information about how LOR controllers can be addressed, see this LOR provided article.
Only one cable per output (from the ActiDongle or PixLite RS485 output) is required. The general order of this cable is:
DMX Source (ActiDongle, PixLite RS485 Output) > #90 Cross Over Cable > CAT5 Female-to-female coupler (included with #90) > Standard CAT5 cable (TIA/EIA T568B) > LOR CAT5 plug on controller (in) > LOR CAT5 plug on controller (out) > Standard CAT5 cable (TIA/EIA T568B) > LOR CAT5 plug on controller (in) > On to additional LOR controllers (up to a max of 512 DMX channels)
|
|
|
|
|
|
|