 |
 |
 |
 |
|
 |
|
Product Features
This OFFSPEC item is the exact same chip, wire and LED as our standard 2811 pixel node, the only difference is that the epoxy used for this batch of pixels was not of the right formulation for high temperature conditions. As a result, the pixel epoxy casting has yellowed while they were stored in our warehouse for the last year. These are still 100% waterproof, still have the same optical characteristics of regular nodes and still safe for use outside, including higher temperatures - this issue is purely cosmetic. Limited stock. Includes our standard warranty for the entire 2015 season.
-
Features
- Please note that these require a smart pixel controller - these will not work with dumb controllers!
- Smart / Pixel Nodes
- Pixel protocol WS2811 (supported by every major pixel controller including DIYL Zeus/SSC)
- Viewing angle of 120 degrees
- Lights
- Total LEDs per node: 3 (Red, Green, Blue)
- Total LED nodes per string: 50
- Total DMX channels required per string: 150 DMX Channels
- Dimensions
- Overall Length from node 1 to node 50: 12 feet, 2 inches
- Node to node (center) distance: ~3 inches
- Lead in and lead out wire length: 4 inches (both ends)
- Maximum diameter of node: 12mm / .47"
- Length of node body: 30mm / 1.21"
- Overall length of node and LED: 1.46"
- Weather
- Silicone body/base
- Epoxy sealed body/casing to ensure waterproof wiring and electronics
- IP68
- Wiring:
- Red = Power Input Anode/+/Positive
- Blue= Power Input Cathode/-/Negative
- White = Data Signal
- Pixel direction is marked with arrows on circuit board (input side)
- Wire size: 34 x .09mm
- Power
- 12v DC Input
- White (all three colors) per node (1 node): 45 miliamps / .55 Watt
- White (all three colors) per string (50 nodes): 2.268 amps / 27 Watts @ 12v DC
- Recommended single run distance without power injection:
- Perfect Output - 100 Nodes
- Average Output - 120 Nodes
- Poor / Non-Full White Output - 150 Nodes
|
|
|
|
|
|
| You might also be interested in... |
|
|
|
|
Pixel RGB Strip 
